[TenTec] Topband: BDR redux

[Jim Reid]

> If AGC Threshold control was reasonably accessible,
> I bet you'd be using it all the time.

Yes,  sure enough!  The Threshold may be set via a
slider at the left side of the "virtual" Orion control
panel when using the N4PY control software.  Very
nice that way.  This continuous control is there all
the time,  no matter which AGC selection has been
made.  There is also a slider for RF gain on that
virtual panel.  I find each to be useful.  BTW,  the
AGC threshold is printed in uV just below the slider
on Carl's panel,  so you always know where it is.

73,  Jim  KH7M