[TenTec] Hi Cut / Lo Cut - Orion
Ten-Tec Inc. Amateur Radio Sales
sales at tentec.com
Mon Jan 5 16:40:21 EST 2004
I'll try to explain Hi Cut / Lo Cut succinctly:
We (Ten-Tec) had a long discussion about whether HI CUT / LO CUT is a
bandwidth value or a passband tuning value when deciding how to update the
display on the Orion - it's actually some of both.
For an example of why LO CUT (and HI CUT) are both a PBT and a BW value,
try this:
Tune in a CW signal. Put your CW offset (using SPOT) at 600 to 700
Hz. Tune the CW signal to match the SPOT tone. Put the BW value at 1000
Hz, PBT at 0, select LO CUT.
As you rotate the LO CUT control clockwise, the PBT value increases as one
side of the filter is moved towards the center of the passband. Because
this also has the effect of narrowing the total filter bandwidth, the BW
value is also updated to reflect the total BW available. As the CUT is
narrowed, however, it is also possible to move past the center frequency of
the filter until the CW signal you are listening to eventually
disappears. The BW will still show a value of maybe 450 Hz or so, as that
is now the BW of the available "distorted" filter after moving one side in
towards or past the original center frequency.
If only the BW was adjusted, not the HI CUT or LO CUT or the PBT, when the
filter was narrowed to 450 Hz you'd still hear the CW signal in the center
of the filter. As opposed to PBT, where the filter BW is constant and the
filter is then moved back and forth across the center frequency. HI or LO
CUT moves one side of the filter or the other towards or past center
frequency.
The PBT and BW values are supposed to update on screen graphics and text -
unfortunately compounding the confusion is a bug that is present when HI
CUT is adjusted. LO CUT shows the adjustment of PBT and BW values
simultaneously, while HI CUT only shows the BW update, not the PBT value.
This needs to be corrected.
Scott Robbins, W4PA
-----------------------------------------------------------------
Ten-Tec, Inc., 1185 Dolly Parton Pkwy, Sevierville, TN 37862 USA
Contact Mon-Fri Eastern: Office/Tech (865) 453-7172 9 am-5 pm.
Repair (865) 428-0364 8-4. Sales (800) 833-7373 9 am-5:30 pm.
Fax (865) 428-4483 24 hrs. Visit us at <http://www.tentec.com>
Email: New product sales/product info sales at tentec.com
Service department service at tentec.com
While we make every effort to answer email in an expedient manner,
the telephone is a much more efficient tool for getting a quicker and
more complete answer to your inquiries. Thanks!
More information about the TenTec
mailing list