[TenTec] Orion issues

[Mark Erbaugh]

Scott,


> For opening and closing filters with less knob turning, I'd suggest
putting
> them at a higher resolution - like 50 Hz or 100 Hz steps rather than the
> default 10 Hz.  10 Hz steps is about 400 Hz BW tuning with a complete
> turn of the encoder knob - you can adjust the knob a small amount when
> using 50 Hz steps and run the filters 800, 850, 900, etc.
>
> It's item PBT / BW Step in the RX menu.
>
> Pushing the RIT encoder resets RIT to zero instantly.
>
> Scott Robbins, W4PA

I don't know if this has changed since I evaluated the Orion in August, but
does the PBT / BW step automatically change with mode?  It would be nice if
the Orion remembered the last step setting. I found it a pain to always have
to go to the menu and change the step when I switched between SSB and CW.

Mark