[TenTec] Question about Mike for OMNI V and Corsair II

OTAKEBI at aol.com OTAKEBI at aol.com
Wed Jan 14 15:49:52 EST 2004


I have a Corsair II and an OMNI V.
When I hook up my Shure 526T Series II to the Corsair II I show peaks of 65 
watts on SSB
however, when I hook the same mike to the OMNI V I only show voice peaks of 
about 45 watts on voice peaks on SSB.
Both radios show 95 watts CW output on tune mode.
The mike is wired for low impedance.
I notice that the OMNI V manual says to use a low impedance mike and the 
Corsair II says it can use high or low impedance mikes.
What gives?
Would a different mike give me better peaks on the OMNI V or does the OMNI V 
have a different system that would produce a more compressed audio output from 
any mike?
Thanks,
Dan N4VET


More information about the TenTec mailing list