[TenTec] Omni VI+: ZERO drift

Robert & Linda McGraw K4TAX RMcGraw at Blomand.Net
Thu Jul 1 21:43:11 EDT 2004


Carter:

ICM = International Crystal Manufacturing which has a website. Here's the
link:  http://www.icmfg.com/tcxo.html#types

I ordered TCXO's based on required frequency of the crystal I was removing.
They are rectangular in shape and will require some spider leg type wiring
in as much as they will not fit in the footprint of the crystals coming out.
Also, you will need to wire Vcc  (+5VDC) to the TCXO unit and add in a pot
from Vcc to ground and connect to the control pin Vc in order to adjust
frequency precisely.  These units cost me about $40 each but if you want the
precision, this is the only way I've found to go.

73
Bob, K4TAX


----- Original Message ----- 
From: "Carter Grabarczyk" <k8vt at ameritech.net>
To: <tentec at contesting.com>
Sent: Thursday, July 01, 2004 5:05 PM
Subject: Re: [TenTec] Omni VI+: ZERO drift


> Robert & Linda McGraw K4TAX wrote:
>
>
> > I too have an OMNI VI+.  It has the TXCO added in place of the
> > crystal oven. And then I discovered that the BFO oscillators did move
> > around a wee bit.  I replaced them with custom TXCO's from ICM and I
> > was amazed at real true stability that then prevailed.
>
> Bob,
> Is it possible for more details; i.e. cost, part number, who/where is
> ICM, ease of change-out, etc.
>
> Thanks,
> 73/Carter/K8VT
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>




More information about the TenTec mailing list