[TenTec] omni d problem

[hdmc38 at bellsouth.net]

Gary

      Unplug the key from the rig then see if it still keys up.If it does I'd start at the mode switch and work back.

                      Joe K4XZ
> 
> From: "Gary L. Ingersoll" <wb8icu at juno.com>
> Date: 2004/07/29 Thu PM 06:59:01 EDT
> To: <tentec at contesting.com>
> Subject: [TenTec] omni d problem
> 
> I have an omni d with a weird problem.  The rig keys up every time the cw position is brought up with the mode switch.  No ground showing up on the t/r  line to explain this.  Also, when turned to the lock position, which SHOULD  key it up, nothing happens.  I am reading about 13 volts on the    T line all th time, tx or rx.  I'm having a hard time following the schematic, since so many things tie together.  Also, all the voltage readings are wrong on the control board.  Since Ten Tec doesnt give me much idea of the inputs expected, I can't tell where to start.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

JOE PATRICK
SENIOR PLUMBING/MECHANICAL
INSPECTOR CITY OF BOYNTON BEACH