[TenTec] Orion Aux I/O

[Phil Howlett]

Plug into "LINE" and get both audios at once dependent on panel volume
control setting.
W9XX


----- Original Message ----- 
From: "Thomas Uhlman" <tuhlman at kimbanet.com>
To: <tentec at contesting.com>
Sent: Sunday, June 06, 2004 3:24 PM
Subject: Re: [TenTec] Orion Aux I/O


> What do you want with the right side audio anyway???
>
> There was a time when I wanted it but determined later (after I managed to
> fabricate a cable) that it wasn't needed afterall.....
>
>
> ----- Original Message ----- 
> From: <N0KHQ at aol.com>
> To: <toby423 at earthlink.net>; <tentec at contesting.com>
> Sent: Sunday, June 06, 2004 4:14 PM
> Subject: [TenTec] Orion Aux I/O
>
>
> > Well Toby, its not going to be as simple as I first thought.
> >
> > The Aux I/O on the Orion is an 8 pin din. The cable as supplied by TT is
a
> 5
> > pin din with 4 RCA plugs on it and is a molded connector. So any hopes
of
> > modifying the existing cable isnt going to work.
> >
> > So, I'll send TT an email asking for the correct cable. I may end up
> making
> > my own.....we'll see.
> >
> > It sure would have been nice if the manual would have said.....this is
> what
> > we're sending and if you want to do this......your on your own.
> >
> > TT did send an 8 pin din plug.......but left out the 7 RCA plugs and
> wiring I
> > will need.
> >
> > Back to Radio Shack.
> >
> > Not complaining.......just an observation.
> >
> >
> > 73
> > John / N0KHQ / St. Louis
> >
> > Always on 18.130
> >
> > Antennas:
> >
> > You can build 'em better than you can buy 'em
> > Please visit the sites below:
> > http://www.hamuniverse.com/17mcoaxmox.html
> > http://www.cebik.com/n0khq.html
> > http://www.ssb-audio.com/forum/
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>