[TenTec] Please explain Omni 6 options ?

[Paul]

You will not be disappointed Peter.

I have an Omni V with the N4PY replacement microprocessor.

It is an excellent radio compared to just about any Japanese radio as far as
RF / on air performance goes.
The front end etc. is the same as Omni VI, quad parallel FET's in the RF amp
and post mixer amp.
Mixer is an SBL1 hot carrier.

I find it bomb proof on 40m under any conditions, and no problem on 160m
either.
It is not deaf.. can hear on 10m better than my FT-102 and a repaired TS-930
that is sitting here.

Paul MW0CDO.

----- Original Message ----- 
From: <G4PUQ at aol.com>
To: <tentec at contesting.com>
Sent: Tuesday, June 22, 2004 7:29 PM
Subject: Re: [TenTec] Please explain Omni 6 options ?


> In a message dated 22/06/2004 14:29:21 GMT Daylight Time,
mark at microenh.com
> writes:
>
>
> > , while Options 2 and 3 were
>
> Thanks for that Mark,
>
> I have just received my Omni VI from Richard GU4CHY. I have cleared a
space
> on the operating position and i'll be on air in about 5 mins....the
> anticipation is incredible:-).
>
> My Omni is a stock radio and I was just wondering what I might need to do
to
> bring it up to top spec. i have received so many good comments about the
Omni
> VI and I am very curious to see how my old but faithful Corsair II stacks
up
> against it.
>
>        I'll let you know, thanks for the info
>
>        73 from across the pond
>
>        de Peter G4PUQ
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>