[TenTec] band stacking

[Steve Ellington]

Are you running cw using the internal keyer as I am Alan? I'm constantly
having some function either quit working  or change on me. For example, the
tuning step menu just went nuts.  and it was showing something like x10m on
the display instead just plain 10 as if it went to metric mode! I finally
did a power reset and it cleared. Turning off the sweep seems to have
helped.
Steve
N4LQ

----- Original Message ----- 
From: "A. Sewell" <n5na at att.net>
To: <tentec at contesting.com>
Sent: Sunday, May 09, 2004 2:56 AM
Subject: Re: [TenTec] band stacking


> Steve,
>
> I don't think it's typical for the rig to lock up while running the sweep.
> I always run my sweep and rarely have any problems with the rig locking
up.
> It has locked up before but it's been a long, long time.
>
> 73,
>
> Alan N5NA
>
> ----- Original Message ----- 
> From: "Steve Ellington" <N4LQ at igLou.com>
> To: <tentec at contesting.com>
> Sent: Saturday, May 08, 2004 9:46 PM
> Subject: Re: [TenTec] band stacking
>
>
> > I took you advice about turning off the sweep and just had 2 hours of
> solids
> > QSO time without a reset. That sweep must eat up a lot of processor and
> > eventually lock up the rig. Wonder if the new firmware will fix that?
> > Steve
> > N4LQ
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>