[TenTec] Service Pack 2 Won't Install (off topic!!)

[Joe Malloy]

Jim Reid wrote:
>  Forgive this,  another off a direct Ten Tec issue topic.
> 
> The update seems to be downloaded just fine.
> But,  I cannot get SP2 for XP to install!  Gets about
> as far as inspecting the "registry"  then an error window
> appears:  "Can't read to or from the data base".....and
> all stops.  Another window shows up advising that SP2
> was not installed,  and all disappears.  Only to have the
> reminder window to come up later advising that updates
> are available to be installed.  This has been going on for
> around a month now.  I'd like to be rid of these continuing
> reminders,  or else get the silly update pack installed.
> 
> How/what do I do about the data base reading issue....
> maybe just forget it,  hi.
> 
> 73,  Jim W6KPI
> On the Garden Island of Kauai
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
If it isn't that much of a problem to do so, Jim, try restoring to an 
earlier date (as early as you can do it without affecting too much 
installed hardware!) and try SP2 installation then.  Perhaps it's just a 
matter of a corrupted registry.  Good luck!

73,

Joe, W2RBA