[TenTec] Jupe+n4py+mixw2

[Carl Moreschi]

Paul,

The K1EL winkey keyer does require its own serial port.  My program
communicates to the winkey keyer over its serial port.  You then just
connect a cable from the keyer output to the Argonaut V keying line.  With
my program ruinning, you can use paddles to key the winkey or just type on
the keyboard.  It works very well.  This is available now with my N4PY Orion
program.  My Pegasus /Jupiter/Argonaut V program will have this support in
the November 1 version.

Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "designer" <designer at quickdata.com>
To: <tentec at contesting.com>
Sent: Thursday, October 14, 2004 1:05 PM
Subject: RE: [TenTec] Jupe+n4py+mixw2


> Carl,
> What exactly is the hookup between WinKey the computer and the Rig. I
> don't suppose the Argo V is supports that right now - but should it
> in the future....Currently I have a serial cable going from Com 3 to
> the serial port on the Argo - that's for your software. I have a
> RASCAL pulled into Com 3, that's for PSK. I have the Paragon II
> plugged into Com 1 controlled by HRD softeware and I have that CW
> serial keyer plugged into Com 2. I figure something will have to go
> if I move to a WinKey - thougth I have two USB ports left.
> Thanks,
> 73
> Paul
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec