[TenTec] Jupiter programming help

[Carl Moreschi]

Tom,

If you are running the Jupiter in front panel mode from a computer, you just
keep track of the VFO A and VFO B frequencies in the program.  To swap VFO A
and VFO B, you send the VFO B frequency to VFO A and the VFO A frequency to
VFO B.  There is no A/B command in the command set.  I hope this helps.

73,

Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "tom" <wa1jvv at yahoo.com>
To: <TenTec at contesting.com>
Sent: Saturday, September 04, 2004 9:51 PM
Subject: [TenTec] Jupiter programming help


> The Jupiter Programmer's Reference Guide gives the commands to set
> freq, filter, mode etc for vfo A and B.
>
> I can't find, or perhaps don't understand, the command to toggle
> between vfo A and B.
>
> Any help?
>
> Tom WA1JVV
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail is new and improved - Check it out!
> http://promotions.yahoo.com/new_mail
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec