Re: Re: [TenTec] Paragon behavior

[nannypoo at mnmars.org]

Using the Ten Tec 961.  

Tim

Phil Chambley <k4dpk at comcast.net> wrote on 09/27/2004, 05:59:24 AM:
> Tim...
> 
> What power supply are you using?
> 
> Phil K4DPK
> VFO Stabilizers, PEP Adapters for Wattmeters ... see
> http://home.comcast.net/~k4dpk
> ----- Original Message ----- 
> From: "Tim & Darlene Isom" 
> To: 
> Sent: Sunday, September 26, 2004 11:29 PM
> Subject: [TenTec] Paragon behavior
> 
> 
> > I am a sysop for a MARS PACTOR switch.  We are using Paragons for
> > the switch operation and I am wondering if anyone has seen the
> > following behavior and if so what is the problem and perhaps the cure.
> >
> > On Saturday, 25 September, I had to check our PACTOR switch
> > because no one was able to log into the switch to get traffic.  I
> > initially found the Paragon working but the audio was just a loud
> > buzz and when the tuning dial was turned the display remained on
> > the same frequency even though I was moving the tuner.  I did a
> > hard reset of the rig and things seemed to be cured.
> >
> > Today, 26 September, I had to again check the switch due to the
> > same problem.  I turned the rig off and on (without a reset) and
> > things were fine, I then had another operator connect to the
> > switch - as traffic was being downloaded by the remote operator
> > the switch was functioning but then stopped - the TNC (a PK232MBX)
> > had the send light lock on, however the rig was no longer
> > transmitting, my loud noise was back and the display was blank.  I
> > do not believe the problem is with the TNC - I believe the issue
> > is related to the radio.
> >
> > Any help would be appreciated.
> >
> > Tim Isom  WD9HDQ/NNN0XEE
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec