[TenTec] Omni VI freq instability, 30m only

[Steve Baron - KB3MM]

Doesn't the VI have a single PLL that runs from 5 Mz to 5.5 MHz?  And
 then a single crystal per band to determine new frequency ?

I recently had a low end of 10M problem that was easilly fixed by replacing
the 10A band crystal.

----- Original Message ----- 
From: "Ben K8DIT" <benk8dit at callatg.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, April 03, 2005 19:08
Subject: Re: [TenTec] Omni VI freq instability, 30m only


> Could be your PLL is  out of lock on 30M.  If your ovenized xtal were
> faultly, all the bands would be acting up. Ben K8DIT
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>