[TenTec] Omni VI power supply

[Carl Moreschi]

Just add one of the AIRPAX magnetic circuit breakers in line with your
supply voltage.  These breakers trip in a few milliseconds and are what
TenTec used to recommend for this problem.  There was quite a discussion of
these on this reflector a year or two ago.  The part number to get is
T11-1-20.0A-01-11C-V.   I seem to remember there was a place in Florida
where these could be ordered.

Carl Moreschi N4PY
Franklinton, NC
> ----- Original Message ----- 
> From: "denton" <denton at oregontrail.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Saturday, April 30, 2005 2:57 PM
> Subject: [TenTec] Omni VI power supply
>
>
> > I have sent my Omni VI back to TT (again) to have the finals replaced.
> > According to Scott I need something that will shut down when the Omni
goes
> > into ocillation.
> > Thus I am asking what power supplies the TT herd is using for Omni VI's.
> > I can put out a want for the Omni's matching supply, but would also like
> to
> > take a look at other things...thanks.
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>