Robert & Linda McGraw K4TAX RMcGraw at Blomand.Net
Wed Aug 17 22:57:35 EDT 2005

Keep in mind that the primary business of Tentec is injection 
molding.........not ham radio.  So they make a few 100000 knobs or so. 
Also, they have a good tool and die shop too.  These 2 parts of the business 
pays for the ham radio hobby end of the business.

Bob, K4TAX

----- Original Message ----- 
From: <OTAKEBI at aol.com>
To: <tentec at contesting.com>
Sent: Wednesday, August 17, 2005 7:12 PM
Subject: Re: [TenTec] MUSHY KNOBS

> Yes, Dave you could buy another knob from Ten Tec but it would break the
> same way the old one did.
> Some people don't even know it is split until they go to turn the 
> bandswitch
> and the knob just spins.
> So, if a better way is found to make a product better why no use it?
> Those non insert knobs have been a problem for Ten Tec too.
> It was just a poor design.
> Even Ten Tec would go with that feeling.
> 73,
> Dan/N4VET
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

More information about the TenTec mailing list