[TenTec] cw filters in omni

[Steve Baron - KB3MM]

the Omni has space for 3 filters, the standard 2400 Hz SSB, a narrow 1800 Hz SSB, and  500 Hz CW.  I would like to instead use the standard SSB, a 500 Hz CW and  250 Hz CW in these three sockets.  Apparently need to equalize gain for the two CW filters.

What are you realy  trying to do?----- Original Message ----- 
From: "Michael Tortorella" <w2iy at verizon.net>
To: <tentec at contesting.com>
Sent: Monday, August 22, 2005 01:30
Subject: [TenTec] cw filters in omni


> Hi to the list,
> I would like to use two CW filters (217 and 219) in my Omni C.  It has
> positions for the 1.8 kHz (218) and 500 Hz (217) filters.  Would like to
put
> the 250 Hz (219) in place of the 1.8 kHz but the manual sayd the IF amp
does
> not have enough gain for two CW filters.  This is essentially the same
reply
> I got from an inquiry to TenTec service "the IF amplifier needs to be
> modified."  Has anyone done this before?  Any advice and/or circuits known
> to work?
> Thanks and 73
> Mike W2IY
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec