[TenTec] RS-232 Control codes for PARAGON

[Bruce Lanning]

Mark, I don't know about the Omni V, but the Paragor (one) that I have has 
the RS232 option installed, and the manual says it's an option. I have the 
old Basic program from TT, but these new computers are too fast to run the 
original Base program for the Paragon. Thanks for the answer. Bruce W1GBS
PS If you should come accross a modern program, let me know....

----- Original Message ----- 
From: "Mark Choate" <aa0yy at sbcglobal.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, December 08, 2005 6:11 PM
Subject: Re: [TenTec] RS-232 Control codes for PARAGON


> Bruce are you sure that the Paragon is even capable of being rig 
> controlled?
> I have an Omni V and had no luck when tried persuing rig control for it.
> Educate me pse.
>
> Mark
>
> ----- Original Message ----- 
> From: "Bruce Lanning" <blanning at acadia.net>
> To: <TenTec at contesting.com>
> Sent: Thursday, December 08, 2005 4:58 PM
> Subject: [TenTec] RS-232 Control codes for PARAGON
>
>
>> Does anyone have a copy of the PARAGON 585 control codes for the RS-232
>> interface option. I would be happy to pay any costs involved. Bruce W1GBS
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>