[TenTec] RS-232 Control codes for PARAGON

[Vic Klein]

Yes, I use computer control of my 585 Paragon all the time using a program I
wrote based on some of the original Ten Tec program concepts. My logging
program (HyperLog) also interfaces with the Paragon to retrieve
band/mode/frequency information. The command language was not widely
supported, though, which is one reason for the Paragon II change to an Icom
control scheme. I know the Omni V and the Paragon were similar in many ways,
but I don't know anything about the Omni V control commands. If they are
similar to the Paragon, my program might be easily modified to run the Omni.

=Vic=
WA4THR
----------------------------------------------------------------------------
-----------------------
To:  "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Subject:  Re: [TenTec] RS-232 Control codes for PARAGON
From:  "Mark Choate" <aa0yy at sbcglobal.net>
Reply-to:  Discussion of Ten-Tec Equipment <tentec at contesting.com>
Date:  Thu, 8 Dec 2005 17:11:04 -0600
List-post:  <mailto:tentec at contesting.com>

Bruce are you sure that the Paragon is even capable of being rig controlled?
I have an Omni V and had no luck when tried persuing rig control for it.
Educate me pse.

Mark