[TenTec] ORION_ANTENNA_SWITCHING

[George K]

Sorry for the lengthy description.
To all that responded to my Orion "band data" switching of a coax relay it 
seems that I can't do what I want to do which is, use the band data plug 
connected to the band data 2 jack to switch an external coax relay.
The problem is, that I still want to use the ant-1 jack for my 160 through 
30 meter operation and the ant-2 jack for my beam. When I choose 20 meters 
the coax relay energizes as it should from the band data plug in #2. When I 
choose 80 meters the relay stays up. There is nothing plugged into band data 
#1. The coax relay does not drop because, as I was told, it's a different 
antenna jack, 160 through 30 meters , and nothing changes. The coax switch 
stays energized. Bummer! I can get it to drop by pressing the MAIN 
RX/TXANT-1 to ANT-2 and back again to ANT-1. This is not "automatic"!
The only way this will work is have ALL bands assigned to antenna -2. Then 
the coax relay connected to band data #2 operates as expected. Ten Tec said, 
"it is what it is!".
Bummer.
I'm trying to think of some logic that I could outboard to provide this 
function but nothing yet.
The reason for all of this is to switch an LDG-1000 auto tuner on the output 
of my amp from the beam, 20-10M, to my bank of wire 16--30M, antennas.
I'm open to any ideas apart from manually switching the output of the LDG.
Thanks.
George