[TenTec] Orion problem

[Toby Pennington]

Don,  Hold user 2 in while turning the power on and this will put you into
the firmware update mode,  and then reload the firmware that you were using.
This may be the only way to unlock the rig.

Toby  W4CAK

----- Original Message ----- 
From: "Don and Diana Cunningham" <wb5hak at duracom.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, December 22, 2005 8:49 PM
Subject: [TenTec] Orion problem


> I was interfacing a PSK-31 interface to my Orion today, and because of
that,
> or coincidentally, the display went off and ALL the front panel LED's on
all
> switches are on all the time.  The lights in the S Meter are off.  I have
> tried the master reset per the manual, checked power supply voltage and
> leads and connector on the back of the Orion, no luck.  Jack, KC3M, sent
me
> the procedure for a "RAM reset", but that also failed.  All the techs are
> out till Tuesday, so couldn't pick anyone's brain there (except Stan in
> sales who told me most of the above to try, hi).  Any thoughts from anyone
> before Tuesday??  My Omni V is perking along, fortunately, but miss the
> Orion already :-(.
> 73,
> Don, WB5HAK
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec