[TenTec] Orion

[Grant Youngman]

If you haven't tried it, do a reset holding the VFO B LCK key.  This clears
RAM memory, and solves a myriad of ills that can be caused by corrupted
RAM-stored variables.  I had to do this with my II when it arrived to get CW
mode to work on the SUB receiver.  

You'll get a Battery Fail message, and then the usual reset queries.  Clear
everything.

Grant/NQ5T

> -----Original Message-----
> From: tentec-bounces at contesting.com 
> [mailto:tentec-bounces at contesting.com] On Behalf Of Don and 
> Diana Cunningham
> Sent: Thursday, December 22, 2005 10:20 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] Orion
> 
> Toby, Carl and all, I re-tried the User 2/power on reset 
> again, and thought it was going to do it.  Turned the lights 
> off, and a "garbled" screen came on with the "system loading" 
> sign, then locked up.  Subsequent tries, over a period do 
> nothing, so with your help, I am afraid I am finding that it 
> gets to take a trip to Tennessee after Christmas.  Thanks to 
> all of you for helping me.  On the bright side, they can 
> check that the CPU/DSP board has in fact been already modded 
> for version 2 scan like sales assured me that the demo units 
> had been done while there!!  At least have a good Omni V to 
> keep me going, hi.
> 73 all,
> Don, WB5HAK 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>