[TenTec] Ten-Tec Omni V FM Module Info

[Rick Williams]

Mike the info you want is on the main / all-in-one Wiring diagram.  In case
you don't have that here's the info:

   Connector U  comes off of the IF/AF board
   Connector 33 comes off of the 9 MHz board
   Connector 75 comes off of the TX Audio / BFO Board
   Connectors S and T come off of the Low Level (Amplifier) Driver / Noise
Blanker Board

I hope this helps.

73, 

Rick 
VE7TK

Website:  http://www3.telus.net/ve7tk  


---------------------------------------------------------

To: 	tentec at contesting.com
Subject: 	[TenTec] Ten-Tec Omni V FM Module Info
From: 	Mike Webb <mikey6429 at yahoo.com>
Reply-to: 	tentec at contesting.com
Date: 	Wed, 9 Feb 2005 09:31:41 -0800 (PST)
List-post: 	<mailto:tentec at contesting.com>

Could I get someone to look at their FM installation
package and tell me where the FM module connects in
the Omni V?  My manual does not cover the FM module so
its not readily apparent.  I want to know which
connectors on which cards are used to drive the FM
card and then receive the FM signal output.

I would appreciate it very much.
Mike KG4RQD