[TenTec] Orion & Tune button

[Mark Erbaugh]

Would some Orion owners check out this and confirm (or refute) what I see?

I understand the operation of the TUNE button is that when you push it, the
Orion puts out approximately 40w for tuning. You push the TUNE button again
to turn it off (this is without the internal tuner, which I don't have).
However, if you push the PWR button while in tune mode, the Orion will
change to the output level set by the PWR value.

Try this, set the PWR at 80 to 100 (full power). Hit the TUNE button. The
Orion shows about 40 watts out. Hit the PWR button and the indicated power
jumpt up.  Hit the TUNE button to stop the tuning. Now, hit the TUNE button
to start the tune process again. On my Orion, the meter indicates the higher
power level and then drops back to the 40 watt level.  However, this may
just be the meter as an external meter indicates that the power output is
constant at the 40 watt level.  This is when transmitting into a dummy load.

73,
Mark