[TenTec] De;ta 580 pinouts

[Peter Inskeep]

Jeff,
The following is from pg. 3-10, "Main Chassis Wiring," in the Delta 580
manual:

Pin #      Goes to:
1            "T"
2            + Reg
3            +13
4,5          NC    (I am not sure that both are NC. Check this)
6            Com
7            N.C.  (normally closed)
8            Gnd
9            N.O.  (normally open)

When viewed from the back, with the slant notch on the lower right
corner, the pins are marked as follows:

    3   6   9

    2   5   8

    1   4   7

All connections are to connector # 60 on the control board - 80557.
The diagram of connector #60 does not show that both pins 4 and 5 of
the accessory plug are not connected.  It shows that one of them, and
they are not numbered, so I can't tell which, goes to R18 on the
control board, and also to the center pin (middle of three) on plugs
#43, offset, and #58, to VFO.

I hope that this is useful, but please don't connect wires to anything
just on the description above.  I may have made a mistake which could
cause you to fry something on the control board.
73's,
Pete, NO2D
PS.  If I could get my defunct scanner to work I might be able to send
you a copy of the page, but, alas, my expensive HP scanner never did
work.


"Jeff Camp" <jcamp2 at cox.net>
Subject:	[TenTec] De;ta 580 pinouts
Date:	Sat, 26 Feb 2005 08:58:13 -0600
To:	tentec at contesting.com

Plain Text Attachment [ Download File | Save to my Yahoo! Briefcase ]

Can anyone tell me what the pinouts are for the 9 pin accessories jack 
on the back of a Delta 580?  I loaned my manual to someone and he has 
misplaced it.

Thanks,
Jeff










		
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - now with 250MB free storage. Learn more.
http://info.mail.yahoo.com/mail_250