[TenTec] cw overshoot

[Steve Baron - KB3MM]

If the meter breaks, maybe TT will do a
replce3ment deal <vbg>

----- Original Message ----- 
From: "bob finger" <finger at goeaston.net>
To: <tentec at contesting.com>
Sent: Monday, February 28, 2005 15:45
Subject: [TenTec] cw overshoot


> Mark: My Orion does this as well if running at about 100 watts.  Ignore
> the meter pinning; it was much worse in earlier firmware.  What is
> important is the power overshooot on the first couple of characters
> sent.  The first few are about 10% higher power than the setting, or
> settling in power output on cw.  This is important only if you are
> driving an amplifier with low drive requirements, and one should then be
> aware of and compensate for it as needed.
>
> I cannot say this is why the meter pins, but suspect it has to have some
> influence.  I see the power overshoot clearly on a scope. The Orion is
> not the only radio that does this, and some are far worse than
> Orion..knowing about it is important so you can take it into account as
> necessary.   73 bob de w9ge
>
> >I just made my first CW QSO with the Orion where I ran full (100w) power.
I
> >noticed that at the beginning of a transmission, the meter would peg as I
> >could hear it hitting the stop.  It quickly dropped back to 100w. I was
> >transmitting into my triband beam which has a pretty low (< 1.5) SWR.  My
> >rise time was set at 8 ms, I was keying at 16 WPM.
> >
> >73,
> >Mark
> >
> >
> >
> >
> >
> >
> >
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>