[TenTec] Centurion Question

[Duane A Calvin]

This could happen if your power is right on the edge of 1000W and a very
small variation in that power would drop it below the value needed to
light that one LED.  I don't know the circuitry, but it could be a 1 Watt
difference that would cause one LED to go out or light back up.

        73,  Duane


On Thu, 20 Jan 2005 20:31:14 -0400 "yv5mbx" <yv5mbx at arrl.net> writes:
> 
> ----- Original Message ----- 
> From: "Javier Remoto" <jlopez at plasticosomega.com>
> To: <tentec at contesting.com>
> Sent: Thursday, January 20, 2005 7:47 PM
> Subject: Centurion Question
> 
> 
> > Hi,
> >
> > I am watching the behavior of my Centurion amp wich is connected 
> to the
> > Orion and found in the first minutes of cw operation I achieve 
> 1000 watts
> on
> > Top-Band but after 10 minutes or so the led scale shows abt 900 
> watts (1
> led
> > on less than with 1000) then later 1000 watts could be seen agn.
> >
> > Grid: 90 dots / 160 - 240 dash ma
> > Plate Amperes: 0.4 dots / 0.8-0.8 dash
> > Stand by: Plate Voltage  abt 280 / Operating: 2.2 - 2.3 KV
> >
> > Is the amp performing reasonable ok in terms of values shown?
> >
> > 73's de Javier
> >
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 


--------------------------------------
Duane Calvin, AC5AA
Austin, Texas

http://home.austin.rr.com/ac5aa