[TenTec] scout 555 interface cable

[ron]

  I WAS TO USE THE RIG BLASTER WITH THE SCOUT USING THE CORRECT CABLE FOR
TEN TEC RADIOS FROM RIG BLASTER.

AUDIO OUT FROM RADIO GOES TO AUDIO IN ON PC. AUDIO OUT ON PC GOES TO AUDIO
IN ON RIG BLASTER. 

CONNECT THE RIGBLASTER CABLE FROM MIKE CONNECTOR ON RADIO TO THE REAR
CONNECTOR ON RIGBLASTER. NOT IN THE FRONT CONNECTOR.

POWER UP YOUR PC THE RIGBLASTER SHOULD TOGGLE FEW TIMES. THIS INDICATES THE
CONNECTIONS TO PC ARE KOSHER.

OH, GOES WITHOUT SAYING, THE SERIAL PORT ON RIGBLASTER GOES TO SERIAL PORT
ON PC. I DID NOT HAVE TO PLAY WITH ANYTHING ON PC OTHER THAN AUDIO LEVELS.

THEN YOU ARE READY TO ROCK N' ROLL!

 
 RON
WB1HGA

BTW:
USING THE ARGONAUT V DID AWAY WITH THE RIGBLASTER. CABLES CONNECT DIRECTLY
TO PC. COOL!