[TenTec] Omni VI & 960 Power Supply

Steve Baron - KB3MM SteveBaron at StarLinX.com
Thu Jan 27 18:02:31 EST 2005


Some time ago, TT told me that the speakers do go bad on the 960.

The bummer was that there was no way to fix/replace them due to the way they
were made.  Replace ment of the whole front panel would be necessary.

Hope I remember that correctly.

Let us all know if I am all wet.

----- Original Message ----- 
From: "Stuart Rohre" <rohre at arlut.utexas.edu>
To: <tentec at contesting.com>
Sent: Thursday, January 27, 2005 21:44
Subject: Re: [TenTec] Omni VI & 960 Power Supply


> The raspy speaker in the power supply upon warm up sounds like warping of
> the speaker frame due to heat and unequal mounting bolt torque.  Try
> loosening all the screws on speaker and then tightening just snug, while
> listening to it.  Heat over time might have warped the voice coil, and in
> its throw, it is dragging at a point.
>
> If you cannot find any suitable torque, try another speaker temporarily
next
> to the faulty one.  That should resolve any RF issue.  Do not overly
torque
> speaker mountings especially when mounted in a cabinet with a heat source.
>
> -Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>




More information about the TenTec mailing list