[TenTec] Omni VI Power output low
Ken Brown
ken.d.brown at verizon.net
Sat Jan 29 17:52:46 EST 2005
Hi all,
I have an Omni VI. When first turned on the CW TX RF power output is
nearly 100 watts, and then after being on for maybe an hour it is down
to about 60 watts. I have not yet got inside to make the adjustments to
R46, R52, R54 & R57 on the 9 MHz Mixer / IF Board as described in the
manual. Since the power drops after it has been on for a while, my guess
is that even if I make the adjustments by the book, it is still going to
drift downward after being on for awhile. If I make the adjustments
AFTER it gets warm and the power drops, then I run the risk that when
the radio first gets turned on it will be putting out too much and
possilbly damaging the PA xsistors. The likely suspect parts that could
be changing as it warms up are U1, U2, Q7, 8, 9, 10 ,11, 12, 13, & 14 on
the mixer/IF board. Or the low level driver might be where it is happening.
Have any of you had a similar problem and if so what was done to fix it.
Yes I know I can send it to Ten-Tec, but they are a long way from here.
The shipping would probably cost 100X the cost of the part(s) that need
changing.
Thanks,
Ken N6KB
More information about the TenTec
mailing list