[TenTec] Ten Tec Net

[Ken Brown]

My Paragons don't go down that low. I wanted to try to listen to SAQ on 
17.2 kHz and found that my Paragon II only goes down to 99.9 kHz. When 
KPH was on the air last week, I used the Paragon II to hear them on all 
their HF frequencies. I was also able to hear them on 426 kHz with the 
Paragon II, but I was not too impressed with the performance. Using my 
160 meter (1/4 wavelength) inverted L, I expected the 426 kHz signal to 
be much stronger that it was. I suspect the Paragon's sensitivity at 426 
kHz is not too hot, and it is probably no better at 100 kHz.

How do you make yours work at 7.51 kHz?

DE N6KB

Robert & Linda McGraw K4TAX wrote:

>My Paragon and my Paragon II both will transmit and receive on that 
>frequency.  Of course since the US ham band is 7.0 to 7.3 MHz I dare not try 
>it except on a dummy load.  -:)
>
>73
>Bob, K4TAX
>
>
>----- Original Message ----- 
>From: "Ken Brown" <ken.d.brown at verizon.net>
>To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
>Sent: Sunday, July 17, 2005 5:45 PM
>Subject: Re: [TenTec] Ten Tec Net
>
>
>  
>
>>>There is also the TT  SDR (Software Defined Radios) on 7.51 Khz at 6 PM
>>>Eastern.
>>>
>>>      
>>>
>>Wow! The 40 km band. What TT rigs work there?
>>
>>
>>_______________________________________________
>>TenTec mailing list
>>TenTec at contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>
>>    
>>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>