[TenTec] Paragon II Info Wanted

[Robert & Linda McGraw K4TAX]

Chuck:

I have a Paragon II along with an original manual.  The only mod I am aware 
of is one that cuts a jumper to allow transmit on all frequencies above 1.8 
MHz.  This allows access to the 60M band.  It is marked HAM on the processor 
board.  There may be one other which changes the AGC hang/attack time.  I'll 
have to look.

As to the VOX not working, be sure the Anti-VOX control is not turned up all 
the way.  Start with all 3 controls, as viewed from the rear of the radio, 
turned fully counter clockwise.  Advance the gain about 1/2 way.  The 
PTT/VOX switch on the front panel should be in the out or released position.

Along with the Paragon II, I have an original Paragon, an Omni VI+.  The 
Paragon II is simply a great radio.  I prefer the receive audio over the 
Omni VI+.  The only added item is an external Timewave DSP 9+ for heterodyne 
and noise improvement/processing and an external keyer being a MFJ-406.

I suggest you order a manual from Tentec.  You'll learn lots about what the 
radio will do.

73
Bob, K4TAX


----- Original Message ----- 
From: "Chuck" <ka6uup at pacbell.net>
To: <tentec at contesting.com>
Sent: Saturday, June 25, 2005 10:58 PM
Subject: [TenTec] Paragon II Info Wanted


>I have a new-to-me Paragon II and am wondering if there are Ten Tec
> approved mods and
> alignment instructions available somewhere?
> Unless I am missing something, it also appears that the vox is not
> working. Any suggestions?
> Tnx es 73,
> Chuck
> KA6UUP
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>