[TenTec] SSB recieve audio?

[Steve N4LQ]

Barry you lost me there. Alignment of what?

Steve Ellington
N4LQ at iglou.com
----- Original Message ----- 
From: "Barry Gross" <barry.n1eu at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, May 29, 2005 10:43 AM
Subject: Re: [TenTec] SSB recieve audio?


> On 5/29/05, Steve N4LQ <n4lq at iglou.com> wrote:
>> I did some measurements on the Omni VI. Nothing below 300hz get's past 
>> the
>> detector. The notch and DSP are not to blame. It has to do with the 
>> position
>> of the BFO within the IF passband.
>
> The lower cutoff of the audio passband (after the detector) is easily
> adjusted by alignment.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>