[TenTec] ORION with Yaesu Quadra amp?
Bob Henderson
bob at cytanet.com.cy
Sun Sep 4 16:24:25 EDT 2005
Expert I am not but I believe the Quadra is band switched by a BCD output
from Yaesu tranceivers. This is what Yaesu call a band data output. So the
Quadra needs a BCD input. Orion on the other hand produces a one from nine
line o/p to drive antenna relays etc. If I'm right, then what is needed is
a 16 to 4 line encoder with TTL outputs to interface between Orion and the
control input of the Quadra. Shouldn't be too difficult.
73
Bob, 5B4AGN
----- Original Message -----
From: "NJ0IP" <Rick at DJ0IP.de>
To: "'Discussion of Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Sunday, September 04, 2005 8:00 PM
Subject: [TenTec] ORION with Yaesu Quadra amp?
> A question for the experts:
>
>
>
> Does anyone make level converter that will allow the Orion to control a
> Yaesu Quadra amplifier?
>
>
>
> Appreciate any tips.
>
>
>
> Tnx
>
>
>
> 73
>
> Rick
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list