[TenTec] Another O2 bug

[RM]

Yep,

I can reliably reproduce this on my Orion II with version 2.030 software

The Orion II is set up in the following manner:

1 frequency 14201.00
2. Initial setting is in USB
3. Internal Tuner engaged and tuned to frequency (SWR of 1.5)
4. VOX set to on.
5. Sweep is engaged

Next

Switch from USB to UCW (VOX turns itself OFF)
Whistle into the microphone
Steady CW signal out put at power setting
To Stop either switch back to USB mode and Push VOX to off,
Or sometimes requires a power off/on to stop the CW transmitted signal

Next, same setup as above except the Sweep is turned off

Results in same problem.

Next, same setup as above except the VOX is turned off in USB

Cannot reproduce the bug.


Ron, NU1U


----- Original Message ----- 
From: "John Nason" <jmnason at yahoo.com>
To: <na9u at arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec at contesting.com>
Sent: Sunday, April 02, 2006 12:30 PM
Subject: [TenTec] Another O2 bug


> Here is another bug if anyone can confirm.
>
> I use the TT 706A microphone, I would be interested in
> knowing if other mikes do this:
>
> 1) Put the rig and the microphone on VOX while on USB
> or LSB.  Make sure the 706A's vox light is on.
>
> 2) Then put the rig on UCW and whisper into the
> microphone or tap it to trigger a transmission.
>
> The rig will lock up transmitting in CW.  I have not
> sent this one in yet.  Anyone else?
>
> Thanks,
> John
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>




_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec