[TenTec] omni d series c display problem

[Mike Hyder -N4NT-]

If the PTO signal is not getting to the counter, this will be the display 
problem.  Here's what I would check:

1.  On rear panel, there is a jumper for the external VFO.  It is two phono 
jacks with a jumper installed.  make sure that jumper is making good contact 
by removing and reinstalling it.  If you are using the external VFO, remove 
it and jumper those two phono sockets to see if that cures the fault.

2.  The old rigs can have trouble with oxides on connectors.  Remove circuit 
boards one by one and reinstall them.  This cleans the contacts for another 
25 years.

If this doesn't work, please ask again, Gustavo.

73, Mike N4NT

----- Original Message ----- 
From: "lw3ewz" <lw3ewz at speedy.com.ar>
To: <tentec at contesting.com>
Sent: Tuesday, April 11, 2006 10:31 PM
Subject: [TenTec] omni d series c display problem


> Dear friends
> i love this rig... but i have a problem
>
> I need te solution at my display problen in my omni d series c
>
> The display look 1.000 in 7 mhz band.  91.000 in 10 mhz, 09000 in 14 mhz 
> and 21 mhz and sudenly the display works fine
>
> what is the problem? and what is the fix or solution?
>
> Sometimes  the display works fine and sudenly works bad again..
>
> thanks in advance
>
> Gustavo A. Andrada
> lw3ewz
>


--------------------------------------------------------------------------------


> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 268.4.0/304 - Release Date: 07/04/2006
>


--------------------------------------------------------------------------------


> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>