[TenTec] Orion Main and Sub frequency difference

[Carl Moreschi]

Yes, I have a full software frequency calibration routine.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Ron Castro" <ronc at sonic.net>
To: "Carl Moreschi" <n4py at arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec at contesting.com>
Sent: Wednesday, April 12, 2006 8:58 PM
Subject: Re: [TenTec] Orion Main and Sub frequency difference


> Do you also have a calibration offset for the main oscillator?
>
> Ron N6AHA
>
> ----- Original Message ----- 
> From: "Carl Moreschi" <n4py at arrl.net>
> To: "tentec" <tentec at contesting.com>
> Sent: Wednesday, April 12, 2006 4:17 PM
> Subject: [TenTec] Orion Main and Sub frequency difference
>
>
> >
> > Bill,
> >
> > I don't know why I never thought of this before but I have a diversity
> > mode
> > in my N4PY Orion program.  It sets the two radios to the same frequency
as
> > you tune
> > with the remote tuning pod.  I can easily put in a user configurable
> > frequency difference in my program to handle a few hertz offset.  I am
> > going
> > to add this to the next version of my program.  Thanks for the idea.
> >
> > 73,
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, NC 28635
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec