[TenTec] Alignment tools for Omni 6 Plus

[Dave Edwards]

Unless it actually has a failure (something broke)
I would strongly reccomend leaving it alone.
There is a reason  for the cliche "If it ain't broke, don't fix it"
If it was an old tube rig built in 1946, then perhaps it may need some 
touching up.
But an Omni 6 plus..built in 1999 or so ..should be the same as new...unless 
someone already mucked with it.

....Dave

----- Original Message ----- 
From: "Lew" <ljl160 at verizon.net>
To: <tentec at contesting.com>
Sent: Friday, April 14, 2006 9:52 AM
Subject: [TenTec] Alignment tools for Omni 6 Plus


>I am going to check alignments on my Omni 6 Plus. A tech friend is helping 
>so before I take the rig over to him,  does anyone know what alignment 
>tools I need? type and sizes etc?? Covers have not been off this awesome 
>rig!! Thanks-73-Lew K1NDV
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec