[TenTec] Elecraft KW Solid State Amps

[Ron Castro]

I saw the earlier post about the amp, but have they released any specs yet 
other than the power and frequency coverage?

Ron N6AHA

----- Original Message ----- 
From: <CATFISHTWO at aol.com>
To: <tentec at contesting.com>
Sent: Tuesday, April 25, 2006 10:01 PM
Subject: Re: [TenTec] Elecraft KW Solid State Amps


>
> I saw it at Visalia, and it is pretty, but I don't think it will replace 
> the
> Alpha 87 a just yet. perhaps as a backup amp??  tom N6AJR
> ============================================================
>
> In a message dated 4/25/2006 10:26:04 A.M. Pacific Daylight Time,
> k4beh at juno.com writes:
>
> Ten-Teckies,
>
> These will be able to follow your Orion and Orion 2  so therefore it is
> applicable to the T-T reflector, isn't it?  Also  since T-T no longer
> produces a solid  state amp,  I thought you  might be  interested.
>
> Pat-K4BEH
> -------------------------------------------------------------------------
> ------------
> The  question was raised on the Elecraft reflector about the status of
> their  soon-to-be-introduced solid state amps. This was Eric's reply to
> the  query............
>
>
> We officially previewed the amplifiers this  weekend in our booth at the
> Visalia DX convention and prior to that we  were not able to answer all
> of the emails we were being flooded with. (I  just got back into the
> office today.)
>
> We previewed working units of  the KPA800 (800W) and KPA1500 (1500W+)
> solid state amplifiers at the show.  We are now going through the FCC
> certification process for these amps  (basically to show that they can't
> be used as CB amplifiers). We can not  take orders until after we receive
> the final certification, which usually  takes 90-120 days.
>
> The KPA 800 is a single box amplifier with an  internal custom designed
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>