[TenTec] Noise Reduction Setting

[Grant Youngman]

> If you gentlemen come up with a set of control parameters 
> that allow the use of DSP NR with CW, please post your solution.

If you operate CW with reasonably narrow bandwidths, DSP NR is largely
superfluous, if not downright useless.  The most effective noise reduction
tool in CW mode (any radio, not just the Orion/II) is the the bandwidth
control.

I know that's not the answer you're looking for, but it is the case.
There's considerable discussion in the reflector archives on the subject.

Grant/NQ5T