[TenTec] Herc II and FT-1000MP AND PRO III

[Phil Chambley, Sr.]

Rich...

I don't have the Pro III manual or schematic, but I feel certain there is
BCD Band Data output on one of the rear apron connectors, so the same simple
circuit would work.

Phil Chambley, Sr.
K4DPK


---- Original Message ----- 
From: "Rich McCabe" <r.mccabe at 1967z28.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, February 16, 2006 10:48 AM
Subject: Re: [TenTec] Herc II and FT-1000MP AND PRO III


> Good question, I was getting ready to ask the same about the PRO III.
>
> I just bought a Hercules II with 100 watt supply and want to connect it to
> my Pro III for band change.
>
> I know there are interfaces out there but I have been unable to find one.
>
> Any direction?
>
> 73,
>
> Rich
> kd0zv
>