[TenTec] Orion meter pegging on CW TX

[Ron Castro]

I just looked closer and R337 is not adjustable, however R340 is.

Ron 
N6AHA


----- Original Message ----- 
From: <k3hx at juno.com>
To: <tentec at contesting.com>
Sent: Saturday, February 18, 2006 12:54 PM
Subject: Re: [TenTec] Orion meter pegging on CW TX


> OM,
> 
> My concern is with the initial dit or dah, the meter needle slams
> 
> against the peg and then stays there as you noted.  
> 
> 73,
> 
> 
> Tim
> 
> -- "Chortek, Robert L" <robert.chortek at berliner.com> wrote:
> The needle on my Orion II goes to the peak value, whatever level that
> may be depending on the power level, and holds at that peak while I
> continue to xmit, without moving between dits and dahs. It is very nice.
> 
> 
> Does yours work differently?
> 
> 73,
> 
> Bob/AA6VB
> 
> Tim Wrote:  When running at indicated PWR levels above "70" the meter
> needle pegs to the right when the transmitter is keyed on CW. I'd be
> grateful to know of a damping technique to remedy this.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> 
> ________________________________________________________________________
> Try Juno Platinum for Free! Then, only $9.95/month!
> Unlimited Internet Access with 1GB of Email Storage.
> Visit http://www.juno.com/value to sign up today!
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
>