[TenTec] Omni D problem

[NZ8J]

Carter,
If you don't find one someplace else, you can always order one from Ten Tec,
they've got them listed on their web site now

http://radio.tentec.com/Support/Manuals

73
NZ8J
----- Original Message -----
From: "Carter, K8VT" <k8vt at ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, January 11, 2006 4:50 PM
Subject: [TenTec] Omni D problem


> Group,
>
> I am working on an Omni D for a friend. The original complaint was low
> output on 160 meters. I removed the RCA plug that goes into the final
> amplifier module and put a scope on it (the output from the driver). All
> levels look similar, but the 160 waveform looks dirty/distorted
> (parasitic oscillation?) compared to the 80-10 waveforms.
>
> It has been suggested that this could be due to an alignment issue.
> Therefore, the following question: Could someone photocopy or scan the
> alignment section from the manual and either e-mail or snail mail to me?
> (Photocopy and postage costs reimbursed). Or, does someone have an Omni
> D manual surplus to their needs they would be willing to sell?
>
> Thanks and 73,
> Carter K8VT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>