[TenTec] Low output on Centruion after lightning

Phil Chambley, Sr. k4dpk at comcast.net
Mon Jul 10 22:05:28 EDT 2006


Are both tubes lit?

Phil
VFO Stabilizers and PEP adapters for wattmeters...Check out
http://home.comcast.net/~k4dpk
----- Original Message ----- 
From: "Billy Cox" <aa4nu at ix.netcom.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, July 10, 2006 8:46 PM
Subject: Re: [TenTec] Low output on Centruion after lightning


What does the amp show for output when driven into a Dummy Load?

I would run that test next, before I started buying new tubes/etc.

Spend some time doing a bit of troubleshooting to find the problem.

73 Billy, AA4NU

----- Original Message ----- 
From: "Jim Miller WB5OXQ" <wb5oxq at grandecom.net>
To: <tentec at contesting.com>
Sent: Sunday, July 09, 2006 10:20 PM
Subject: [TenTec] Low output on Centruion after lightning


>I have a Centurion about 6 years old that has always made around 1200-1300
>watts on all hf bands except about 1000 on 10 meters.  I recently had a
>lightning strike to my fiberglass dual band vhf uhf antenna on a different
>tower from my hf antennas and neither of my hf transceivers were damaged.
>I now find that I can only get about 700 watts on any band driving the amp
>with either transceiver.  Could this have damaged the tubes?  I don't mind
>a new pair of 3-500's if that will fix the problem.  Should I buy the
>regular 3-500z tubes or the zg graphite models.  Will I gain anything by
>using the graphite plate tubes?  Any mods anyone can recommend that will
>improve the amp performance while I am in there?  Suggestions please!
>
>      Jim & Ella Miller
> WB5OXQ & KA5EPM
>     Abby & Sparky
> Dalmatian Furbabies
>        Waco, TX
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list