[TenTec] Running AL-811 with Jupiter

[Dave Tipton]

Per the manual, you should NEVER drive that amp with more than 80 watts.
   
  In the tune up instructions, it very specifically says start with as little input as you can, and then increase it gradually..  At least, that's what it says for the 811H.  I run a Jupiter (Without the ALC Hooked up to the amp) and have no problems at all putting 50 Watts into the 811 and getting 850 Watts out of it on 40M.
   
  Dave

Ron Grace <rjgdag at ntelos.net> wrote:
  do you have tha alc hooked up? try running without it. af4ob
----- Original Message ----- 
From: "Glenn HessJr." 
To: 
Sent: Sunday, June 25, 2006 10:53 AM
Subject: [TenTec] Running AL-811 with Jupiter


> To all,
>
> I am have a problem running my AL811 amp with my Jupiter. I cannot get 
> the
> amp to put out more than 50 watts even when I drive it with 100 watts.
>
> I confirmed all three tubes are "lit" in the amp.
>
> The amp worked fine with my Triton, but doesn't seem to like the Jupiter. 
> I
> must be doing something wrong.
>
> Anyone experience the same problem before?
>
> Thanks,
>
>
> Glenn HessJr.
> glennhess at earthlink.net
> EarthLink Revolves Around You.
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> __________ NOD32 1.1622 (20060625) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.eset.com
>
> 

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec