[TenTec] 2.031 QSK bug - this is not a bug

ROBERT CARROLL w2wg at comcast.net
Fri Mar 3 17:33:26 EST 2006


With the AL80B and Al1500, neither of which are QSK, I can hear pretty well
when the Orion drops back into receive but the relays in the amps have not
been released--sort of like having QSK in a non-QSK amp.  I ordinarily use
an Alpha in full QSK, but I was a little surprised to discover how much
signal leaked back with the Ameritrons.

Bob W2WG

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Ron Castro
Sent: Friday, March 03, 2006 4:50 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug

The Ten Tec keying loop in the 425 is probably different than the Ameritron.

It is possible to hear with the linear in transmit, and in fact I did, just 
not very well.  There is enough inter-electrode capacitance in the 3CX800's 
to pass some signal back from the antenna to the input.  Sort of an 
attenuator with 2,400 VDC on it!

Ron Castro
Chief Technical Officer
Results Radio, LLC


----- Original Message ----- 
From: "Grant Youngman" <nq5t at comcast.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Friday, March 03, 2006 11:30 AM
Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug


>> Ron - if the QSK loop is open, the rig does not transmit.
>
> His problem was that 2.031 seemed to "stick" with TX OUT pulled low keying
> his amp even though the radio was in receive mode ??  (Is that even
> possible?)
>
> I've been playing with mine using the loop on an AL-1200 on and off all
> morning, seeing if I could duplicate it, but it's working without a hitch.
>
> Grant/NQ5T
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




More information about the TenTec mailing list