[TenTec] V1.373b3 anomaly?

Larry Menzel retire at means.net
Mon Mar 6 18:31:51 EST 2006


Did you do a master reset after installing the firmware?

You don't indicate.

Larry, N0XB
 

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Lou Laderman
Sent: Monday, March 06, 2006 5:22 PM
To: tentec at contesting.com
Subject: [TenTec] V1.373b3 anomaly?

I installed v1.373b3 to check out, and have run into something unusual
(to me in any event). When I move the BW encoder, "DSP T/O" appears on
the display in the "send 2" area, continuing to the right below XIT on
the main receiver information. This doesn't seem to affect the operation
of the radio, and clears out when I power down and up again. It
reappears however. Has anyone else experienced this, and does it mean
anything?

Lou, W0FK





_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.375 / Virus Database: 268.1.2/274 - Release Date: 3/3/2006
 



More information about the TenTec mailing list