[TenTec] Another 2.033 problem

[Ron Castro]

I did the test with just the notch, both manual and automatic.  The 
artifacts were continuous and related to the modulation in the passband, 
although when there was no modulation, there were no artifacts.  I can best 
describe it as sounding like overdriving a digital circuit.  I noticed it at 
all levels of automatic, but listening to the same SW station a few minutes 
later after loading 2.032, I didn't hear it at all.

Ron N6AHA


----- Original Message ----- 
From: "Lin Davis" <linbdavis at earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, May 04, 2006 6:42 PM
Subject: Re: [TenTec] Another 2.033 problem


> Hi Ron,
>
> Just curious if you have hardware NB on when you experience the artifacts. 
> I
> haven't put v2.033 on yet.
>
> I just had a listen to a 40 meters, about 1 khz above a strong BC, with AN 
> set
> to 9 and hear a popping noise every few seconds. HW and FW NB off. NR Off. 
> NOTCH
> off.(with v.2.032). Does this sound like what your hearing? Some are quite 
> loud.
>
> Lin
> WB1AIW
>
>
>
> Ron Castro wrote:
>
>> I just noticed, and verified another problem with the 2.033 firmware. 
>> Both the manual Notch and Auto Notch now cause noticeable artifacts when 
>> they have nulled a carrier.  The artifacts were not present in 2.032 and 
>> before.
>>
>> (Flame suit on and ready for barrage of hate mail from folks who think I 
>> hate my Orion and despise every molecule of silicone in it and I'm out to 
>> slander and defame all TT employees and their mothers and call their 
>> children 'ugly', too!)
>>
>> Anybody got a dirt sandwich I can eat for reporting this?
>>
>> Ron N6AHA
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>