[TenTec] Relay for Corsair, argosy

[James Duffer]

I am assuming that you are going to use the supplied power cable, that has 
an extra pair of wires, if you do you could just connect the pair that is 
routed to the power switch on the  Corsair, in series with the astron power 
on/off switch.  Leaving the astron power switch in the ON position, you 
would then have control of the power to the Corsair with the Corsair 
AF/Power control.  You may have been considering installating a relay in the 
Corsair utilizing the AF/Power control if so my advice is of no use.

Good luck with the project.

Jim, de wd4air


>From: Tod Glenn <n7jqw at cordite.com>
>Reply-To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
>To: Discussion of Ten-Tec Equipment <TenTec at contesting.com>
>Subject: [TenTec] Relay for Corsair, argosy
>Date: Tue, 16 May 2006 20:30:47 -0600
>
>Greetings all.
>
>I'd like to be able to use the AF power switch on my Corsair and
>Argosy with my Astron PS.  TenTec states that the AF switch is not
>rated to use 12v at the required amperage.  They recommend using a
>relay, Guardian series 200 or Potter Brumfield PR3DYO.  Neither seems
>readily available.  Can anyone recommend a suitable replacement?
>
>Thanks.
>
>----
>Tod Glenn
>N7JQW
>NAQCC #1283
>SKCC #1444
>FISTS #12134
>ARCI #12420
>n7jqw at cordite.com
>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec