[TenTec] ICOM Pro III and Ten-Tec Titan III

[joel hallas]

Interesting question. I've wondered about this for a while and had an 
opportunity to try my Centaur amplifier with a FT-2000 (in place of my 
usual Paragon) in full QSK  mode this weekend.

What I did was hook an external keyer to the "key in" jack of the 
amplifier and hooked the amplifier "key out" to one of the FT-2000 key 
jacks, thus taking advantage of the sequencing in the TT amp. The 
FT-2000 key jack was set to operate without the internal keyer. It 
seemed to work fine and reports were that the keying sounded the same 
either semi or full QSK.

I did have a xmit lock-up but only on 80 m, so most probably a local 
grounding issue, not a systematic problem of the connections.

Good to know about the possibilities!

73, Joel
Joel R. Hallas, W1ZR

Ken Kinyon wrote:

>If any one is using the Pro III with a Ten-Tec Titan III. I have some questions
>about what hook up you use. Particularly with QSK CW.
>Thanks,
>Ken W7TS
>
>-------------------
>Kenneth E.  Kinyon
>34 Princeton Circle
>Longmont, CO 80503-2106
>-----------------------
>E-mail: W7TS at comcast.net
>------------------
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>